Ye Olde Inn

Kurgan wrote:I recognize the Creature from Reaper Bones. What did you use for bases?

25x25 bases are from Zealot and the 25x50 bases are 3d prints from whitebeard. I used them all up but have Zealot ones too.

Good choice for the new entries! I have most of that figures and always thought they look good for extra HQ characters.
I particular like the Chaos Warrior, the Evil Cleric and the Grim Reaper you used for the Witch Lord (missing the bottom of his weapon here). The female Wizard is also very nice but I think the pre-slotta female characters are a bit small to fit properly.
Are they the original metal minis pinned on to the base? WOuld be nice to see a group pic with some HQ plastic figures for comparison.

That Creature (Burrowing Behemoth, right?) can skateboard anywhere he wants to!

lestodante wrote:Good choice for the new entries! I have most of that figures and always thought they look good for extra HQ characters.
I particular like the Chaos Warrior, the Evil Cleric and the Grim Reaper you used for the Witch Lord (missing the bottom of his weapon here). The female Wizard is also very nice but I think the pre-slotta female characters are a bit small to fit properly.
Are they the original metal minis pinned on to the base? WOuld be nice to see a group pic with some HQ plastic figures for comparison.

Some of the pre-slotta figures I found to be small. The ones I used fit nicely. I can put up comparison pics later. These are original models glued to bases. The Witch Lord was particularly difficult to remove the base, as it was very large and thick. He unfortunately came missing the end of the staff, I didn’t think it affected the image I wanted though. I used a Dremel and cleaned up with an X-acto.