Page 1 of 1

Not another Gelatinous Cube

PostPosted: September 13th, 2022, 7:13 pm
by monnock777
Warpslime Blob

Move 3
Attack 4
Defend 6
Body 4
Mind 0

Ability
Digest: If Warpslime Blob occupies same square as a hero, Warpslime my attack hero.
Corrosion: If Warpslime damage hero, that hero suffers Rust spell effect. Hero may roll 1 white combat die, if they roll a shield Corrosion has no effect.

Warpslime is a living, partially aware, and entirely unnatural creature that is born as a result of extensive Warpstone experimentation in a contained environment. The jelly-like protoplasm, hence their popular names of Jellies, Slimes, and Blobs. They flow over solid surfaces or swim through liquids with an undulating motion and can move over almost any surface, including walls and ceilings, seeping through even the narrowest of cracks and crevices. This sticky ooze come in various colors ranging from green, blue to even black, but its most dangerous property is its hunger for metal, particularly iron and copper. It creeps slowly towards the nearest food source, for it needs to feed regularly on these metals. Skaven engineers keep piles of scrap metal handy to throw into these pools at regular intervals, lest their work suddenly dissolve (and then explode) before their eyes. When they run out of scrap metal, they use slaves instead, because in a pinch the slime makes do with the minerals it finds in blood.

Re: Not another Gelatinous Cube

PostPosted: September 14th, 2022, 11:04 pm
by Kurgan
I thought that there were already too many monsters out there, but then I realized there's always room for Jell-O! :mrgreen:

Re: Not another Gelatinous Cube

PostPosted: September 16th, 2022, 1:03 am
by Count Mohawk
Mmmm, Jello. I should make some more of that stuff.

I quite like the concept of this monster - it's dangerous and very tough to kill, but also slow as molasses, so playing "keep-away" becomes a valid strategy. Heroes better hope the room exits don't get cut off!

Re: Not another Gelatinous Cube

PostPosted: September 16th, 2022, 8:57 am
by monnock777
Thanks...

here is the model I am thinking of printing.



https://www.thingiverse.com/thing:3293635