Sjeng's HeroQuest box
Posted: June 22nd, 2013, 11:06 amMost of you have already seen my homemade HeroQuest box:
I've just finished this little project to keep my minis safe into place without sliding around.
check the blog for instructions how to make it. It's very simple!
Sjeng wrote:Well, my box is DONE! yes!!! lots of work, but here's the result:
The box, closed and opened, with the HQ logo burned into the lid. I used a print and carbon paper to trace the lines. Then burned the lines into the wood.
The bottom has felt pads to avoid sratches. The chain holding the lid fits nidely besides the inlay box. The small ridges in the bottom serve to support the inlay box.
There's room for all my HQ, D&D and Dragon Strike stuff on the bottom, and I've made the spacers so they can fit the D&D boards as well. My Questbook is printed on A4 paper, and has all the official HQ questbooks from this website, plus the 4 magazine quests, and some extra quests too. Printed single sided, so if I printed double-sided, I could have fitted in more quests.
The inlay has plenty of room for all my HQ mini's (most are being painted atm), my D&D mini's, my DS mini's, and probably some of my Mantic mini's as well.
I love the result!
I've just finished this little project to keep my minis safe into place without sliding around.
check the blog for instructions how to make it. It's very simple!
Now it's even cooler!
45 degrees no problem! bumping the boc, also no problem. I've stuck the foam tape on snugly so the bases just fit.